These tips are specifically for Adams Readyboard available locally at Dollar Tree cut on our 80 watt CO2 Epilog Fusion Pro machines.

NOTE: FOAMBOARD WILL WARP WHEN ENGRAVED.

used two passes at Power 30% Speed 100%. You may need to pin down the edges of the foamboard.

NOTE: FOAM WILL RETRACT FROM THE CUT EDGES

It is possible to cut the paper on the top side without cutting the paper on the bottom. To do this Fred used one pass Power 20% Speed 100% Freq 50%.

To cut all the way through the foamboard Fred uses two passes Power 25% Speed 100% Freq 50%.

Thank you to Fred deBoard for sharing these tips. If you have questions about cutting foam board talk to Fred.