This is an old revision of the document!
Table of Contents
Epilog Laser Focus Instructions
Use the Cutting Table
The Epilog laser focus is calibrated for the cutting table. I have not tested it with the engraving table.
Use Manual Focus
Usually proper focus is important to achieve the desired results. After some tests, I found that manual focus is much more reliable than autofocus on the Fusion Pro 48. I recommend everyone use the manual focus method. If you don't remember how to use manual focus ask someone for help or message me on WhatsApp to make an appointment.
Focus = Material Thickness
Under normal circumstances the distance shown in the Focus Menu should be about the same as your material thickness. For instance, if I'm engraving on 1/4 inch ply, then after manual focus the focus menu should show about 0.25. Error is often in the range of 0.03, so a number between 0.22 and 0.28 would be normal. If the focus plane is different from the thickness of your material then check for warp. You should also check that your material is flat against the bed. If you push down on your material and it goes down then it isn't flat. If your material is flat and seated properly and the focus error is greater than 0.05 then ask someone for assistance. See “How focus numbers work” at the end of this page for more details.
Turn off Autofocus in Job Manager Dashboard
Auto-focus should always be turned off in the dashboard.
How focus numbers work
The number on the focus menu is the elevation of the focal plane above the cutting table. If you put a piece of paper on the cutting table and use manual focus (very carefully, the motors could push a hole through the paper) then your focus plane should be at almost zero. If you put 1/8 inch ply on the table and focus correctly then the Focus menu should read about 0.125. Under most conditions your focal point should be at the top of the material, which is at an elevation above the cutting table equal to the thickness of your material. Advanced users might want to put the focal point inside the material. If you do that then you are more skilled than me and don't need to read these instructions.
Focused for Maximum Intensity
The laser is focused for maximum intensity which is slightly different that the waist of the focused beam. When I say focal plane I'm talking about the plane of maximum intensity not the plane where the beam is of minimum diameter. This is possibly a nit-picky deatil since it is likely that the two planes are very close together.
