start
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
| start [2024/08/20 04:21] – created makeradmin | start [2024/09/24 23:49] (current) – andrewhowlett | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | This is the front page | + | This is a place to organize information that may help people at Grey Bruce Makers. |
| + | |||
| + | ===== Digital Fabrication Lab ===== | ||
| + | |||
| + | ==== Epilog Fusion Pro ==== | ||
| + | |||
| + | * [[EpilogLaserFocus|Epilog Laser Focus Instructions]] | ||
| + | * [[EpilogLaserCleaning|Epilog Laser Cleaning The Trays]] | ||
| + | * [[FoamboardTips1|Tips for Engraving and Cutting Foamboard]] | ||
| + | * [[AnnodizedAluminum|Annodized Aluminum]] | ||
| + | |||
| + | ==== 3d Printers ==== | ||
| + | |||
| + | * [[PETG|Printing with PETG]] | ||
| + | * [[PETG-Oozing|Warning: | ||
| + | |||
| + | ==== 3d Scanner ==== | ||
| + | |||
| + | * [[Einscan-Notes|Andrew' | ||
start.1724127669.txt.gz · Last modified: 2024/08/20 04:21 by makeradmin
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
